September 24, 2010 | Filed Under Uncategorized
Rob at M/Gateway Developments pointed out that I was referring to procedures, not functions, in an earlier post (oh dear!). So here we go with the right names:
Here is PROCEDURE1.mac:
PROCEDURE1 Write "Here we are in PROCEDURE1", ! Set LocalVariable=0 Write "We LocalVariable = ", LocalVariable, ! Write "Calling PROCEDURE2...", ! Do ^PROCEDURE2 Write "Now we LocalVariable = ", LocalVariable, !
Here is PROCEDURE2.mac:
PROCEDURE2 Set LocalVariable=666
Now run it in a fresh terminal:
USER>Do ^PROCEDURE1 Here we are in PROCEDURE1 We LocalVariable = 0 Calling PROCEDURE2... Now we LocalVariable = 666 USER>
So by default, what look like local variables actually travel along the calling chain because Mumps uses dynamic scope.
Rob replied with this example:
procedure1 new LocalVariable,newVar Write "Here we are in function1", ! Set LocalVariable=0 Write "We LocalVariable = "_LocalVariable, ! Write "Calling function2...", ! set newVar=$$function2() Write "LocalVariable is still = "_ LocalVariable, ! Write "newVar="_newVar QUIT function2() new LocalVariable set LocalVariable=666 Write "In function2 with LocalVariable="_LocalVariable set LocalVariable=$$function3() Write "Now LocalVariable has been updated to "_LocalVariable QUIT LocalVariable function3() QUIT 777
… and wrote:
It should run correctly in the way you’d expect, with LocalVariable properly lexically scoped. Procedures don’t have to have formal parameters, but functions must, even if it’s an empty list as above. Procedures just QUIT at the end. Functions quit with a return value and are invoked using the $$ at the front of the name. Procedures are invoked with a Do.
That cleared up some of my (mis)understanding of the scoping rules. Unfortunately the large Mumps system that I have worked on uses procedures almost all of the time (not functions) and no formal parameter lists and I took that as a given.